YOUR ULTIMATE GUIDE TO CEMENT CUTTING 

 

Concrete is a solid, tough, climate-safe material ideal for paths, carports, yards, pool surrounds, grill areas, firepits, landscape curbing, and more. Yet, what do you do when you have to make changes to your concrete? Rather than separating and detaching a whole concrete installation, you can make smaller, more effective cuts on the off chance that you have the correct hardware and skill to cut cement.

Here are some ideas that you could follow in your cement cutting:

 

Decide Which Blade to Use 

A dry edge permits you to utilize your standard circular saw. It implies you don’t need to lease a wet saw or a “walk-behind” to give you a consistent stream of water. The drawback with a dry sharp edge is the cutting depth. Best case scenario, you will get a depth of 2.25 inches to 3 inches, contingent upon the size of the cutting edge. 

A wet slice edge stretches out that depth to between 4.5 inches and 8 inches. It implies you can make clean cuts completely through the material without requiring a chisel or a sledge. You likewise get a more extended, persistent cutting movement for cleaner cuts. Additionally, the sharp edge is water-lubricated, so there is no compelling reason to continue halting to let the blade cool off. 

 

concrete blade

Maintain Your Blades 

While each different kind of saw offers its own advantages and capacities, none of them can carry out the responsibility if your cutting edges are deficient. A dull sharp edge will frequently break your cut, and it puts extra pressure and heat on your saw, which destroys it quicker. Cuts with more blunt cutting edges will likewise deliver more residue. On the off chance that your solid cutting task requires a lot of cuts, you’ll need to put resources into heavy-duty blades to abstain from changing them out continually. For smaller tasks, just watch for indications of wear, and change sharp edges before the cut quality is undermined. 

 

Tape the Saw to Prevent Scratches 

Put a piece of duct tape along the base of the saw body where it runs against the solid. This will shield the saw from scratching the solid surface as you cut. 

 

Chalk the Cutting Line 

Drawing the cutting line on the concrete before you slice is important to be certain that you don’t wander from where you need the slice to be made. Utilize a thick chalk line to check where you intend to cut, and ensure it is effectively noticeable as you work. 

 

Preparing the Work Space 

On the off chance that you are working inside, tape up entryways and air admissions utilizing the drop cloths and the duct tape. This prevents the residue from getting away or discovering its way into places where it could cause harm or contamination. 

 

 

Diversify Your Sharp Edges 

There are various kinds of sharp edges accessible too, and each has various capacities. For instance, a diamond-covered edge is ideal when cutting strengthened cement, however a wet sharp edge will perform better against dust. In any event, when a solitary saw will deal with a task, various edges might be required relying upon the particular cut, so make certain to assess the environment and have numerous edges available

 

Use a Guide Board 

Secure a straight, smooth board along the outside of the chalk line. Keep up a steady, firm, two-handed hold on the saw and gradually push the saw ahead firmly against the guide board. 

 

Wet the Concrete 

Wetting down the concrete will help limit dust as well as keep the concrete and cutting edge cooler. A continuous stream of water is ideal, but may not be feasible for each undertaking. On the off chance that it is essential, quit slicing intermittently to rewet the area as required. 

 

I trust that these thoughts are valuable to you as you achieve your concrete cutting undertakings. You can view more ideas about how to cut concrete by looking for more information on the internet.

 

You may also like

Leave a Reply

Your email address will not be published. Required fields are marked *